4.23 HDD cable/LAN jack/RGB board cable 4 Replacement Procedures
TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633) [CONFIDENTIAL] 4-65
Installing the HDD cable/LAN jack/RGB board cable
To install the HDD cable/LAN jack/RGB board cable, follow the steps below and refer to
Figure 4-37.
1. Connect the LAN jack and RGB board cable to the connector CN4100 and CN9500
on the system board.
2. Connect the HDD cable to the connector CN1900 on the system board and stick the
insulator in place.
To Next Page
Loading...
