6
E6582188
Step 2
Remove Top-cover from Inverter with untightening 4pcs M4 screws.
[NOTICE]
Their 4 screws are “pozidriv”.
Please be careful when they are untightened.
Step 3
Remove 3pcs M8 nuts (circled on right figure). Keep these nuts. They must be reused later.
PB7-4132K is equipped:
Go to Step 4A, 5A, and 6A
PB7-4132K is not equipped:
Go to Step 4B, 5B, and 6B
To Next Page
Loading...
