To Next PageTo Next Page
Need help?Do you have a question about the Toshiba TOSVERT VF-AS1 Series and is the answer not in the manual?
General| Category | Inverter |
|---|---|
| Input Frequency | 50/60 Hz ±5% |
| Series | VF-AS1 |
| Overload Capacity | 150% for 60 seconds |
| Input Voltage | 3-phase 200 to 240 VAC |
| Protection Degree | IP20 |
| Ambient Temperature | -10 to +50 °C (14 to 122°F) (Open type) |
| Protection Functions | Overcurrent, Overvoltage, Undervoltage, Overheating, Ground Fault |
| Braking Unit | Built-in |
| Communication | RS485 |
| Power Range | 0.4 to 110 kW |
| Cooling Method | Forced Air Cooling |
| Operating Temperature | -10 to +50 °C (14 to 122°F) (Open type) |
| Altitude | Up to 1000 m |
| Output Voltage | 3-phase, voltage corresponding to input voltage |
Details the necessary parameter settings for the inverter and option unit to function correctly.
Explains how to manually or automatically assign IP addresses, subnet masks, and gateway addresses.
Configures the inverter's response to communication timeouts and network disconnections.
Defines parameters for sending commands and receiving monitoring data via communication.
Details the bits and functions of the first command word for drive control.
Details the bits and functions of the second command word for drive control.
Specifies how to set frequency references using the communication option.
Explains error messages related to hardware, software, or connection issues with options.
Describes the inverter's behavior and error indication for network cable disconnection.
