E6581581
- 10 -
3.2. The details of the parameter setting
3.2.1. DEVICE NAME (f792-f799)
The Device Name is possible to 16 characters to device name parameters.
The device name is required if the card uses DHCP to obtain its IP Address.
Please set the setting of the device name according to the following rules.
1. The parameter is displayed by the hexadecimal number.
2. One parameter shows two ASCII codes.
3. The relation between the device name and the parameter is as follows.
Example for Device Name =’VFAS1-4007’
Example
Parameter Characters No. Higher or
Lower bit
ASCII Setting value
1 Higher bit ‘V’ (0x56)
f792
2 Lower bit ‘F’ (0x46)
0x5646
3 Higher bit ‘A’ (0x41)
f793
4 Lower bit ‘S’ (0x53)
0x4153
5 Higher bit ‘1’ (0x31)
f794
6 Lower bit ‘-‘ (0x2D)
0x312D
7 Higher bit ‘4’ (0x34)
f795
8 Lower bit ‘0’ (0x30)
0x3430
9 Higher bit ‘0’ (0x30)
f796
10 Lower bit ‘7’ (0x37)
0x3037
11 Higher bit ‘(’ (0x28)
f797
12 Lower bit ‘V’ (0x56)
0x2856
13 Higher bit ‘1’ (0x31)
f798
14 Lower bit ‘5’ (0x35)
0x3135
15 Higher bit ‘4’ (0x34)
f799
16 Lower bit ‘)’ (0x29)
0x3429