E6581581
- 9 -
Title
Communi
cation No.
Function Description
Default
setting
f856 0856
Number of motor pole pair
for communication
1: 2 poles
2: 4 poles
3: 6 poles
4: 8 poles
5: 10 poles
6: 12 poles
7: 14 poles
8: 16 poles
2
f899 0899
Network option reset
setting
0:None
1:Reset option circuit board and inverter
0
-
FE66
Add-on option 1 CPU
version (Under side option)
-
-
FE67
Add-on option 2 CPU
version (Panel side)
High byte is version. Low byte is revision.
For example, When version number 1, and revision
number 2 is, panel indication becomes with 1.02.
The version of the option with it has equipped can be
checked by using the function of f710 to f718
(standard monitor display selection).
*For details, refer to the inverter instruction manual.
-
(*1): This parameter is effective by reset. Please reset (power supply reset or f899=1) after changing a set point.
(*2): The Factory default setting parameter () does not work for this parameter.
Warning
Mandatory
action
Set up “Network error detection (f849 - f852)” parameters to stop the inverter when
EtherNet/IP™ communication is deactivated.
When the parameters are changed, the power must be cycled to the VF-AS1 for the
changes to take effect.
To Next Page
Loading...
