no guarantee that Interference will not occur In a particularinstallation. If this equipment does cause harmful
interference to radio ortelevision reception, which can be determined by turning the equipment off andon, the user is
encouraged to try to correct the interference by one or more of thefollowing measures:
• Reorient or
relocate the receiving antenna.
• Increase the separation bet
ween the equipment and receiver
.
• Connect the eq
uipment into an outlet on a circuit different from that to whichthe receiver is connecte
d.
• Consult the dea
ler or an experienced radio/TV te
chnician for help.
Wa
rning: Changes or modifications to this unit not expressly approved by the partyresponsible for compliance could
void the user’s authority to operate the equipment.
IC Compliance Statement: This device complies with Industry Canada’s licence-exempt RSSs.Operation is subject
to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Maintenance
To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this sy
stem.
• Before using chemical cloth, read the instructions that came
with the cloth carefully.
Getting started
This unit has a built-in lithium polymer ion rechargeable battery. Before use, fully charge thebattery by connecting the
unit to a computer or a universal USB mobile charger through theprovided USB charging cable.
The red Charge indicator turns on while the battery is charging. The red indicator will turn offwhen the battery is fully
charged (around 2 hours).
Note
• When th
e battery voltage is too low, a low voltage sound is heard. Charge the unit.
Controls and indicators
1 Decoration ring
2 Speaker driver
3 Charge indicator (Red)
4 Micro USB charge socket / Line-in socket
5 Bluetooth?indicator (Blue)
6 Power button / Play button / Pause button
Using this speaker
Cet appareil est conforme aux CNR exemptes de licence d'Industrie Canada . Son fonctionnement est soumis aux deux conditions suivantes :
( 1 ) Ce dispositif ne peut causer d'interférences ; et
( 2 ) Ce dispositif doit accepter toute interférence , y compris les interférences qui peuvent causer un mauvais fonctionnement de l'appareil.
To Next Page
