Toshiba W-603 - Head Switching Point Adjustment; Nvram Option Setting

Alignment and Adjustment
Toshiba
5-9
5-3 Head Switching Point Adjustment
1) Playback the alignment tape.
2) Intermittently short-circuit the two test points on Main PCB to set the adjustment mode. (See Fig. 5-2)
3) Press the “SP/SLP” button of remote control then adjustment is operated automatically. (See Fig. 5-1)
4) Turn the Power off.
5-4 NVRAM Option Setting
1) Intermittently short-circuit the two test points on Main PCB to set the adjustment mode. (See Fig. 5-2)
2) Press the “PROG.” button of remote control about 5 seconds then option setting display is appeared.
(See Fig. 5-17)
3) Select the option number (See Table 5-2) of corresponding model with “FF” and “REW” button of remote
control.
4) If selecting the option number is completed, press the “PLAY” button of remote control.
(If “PLAY” button is pressed, the selected number is changes reversed color. ; See Fig. 5-17)
5) Press the “ENTER” button of remote control again to store the option number.
(“SAVE” is displayed for a second as shown Fig. 5-18 this setting is completed.)
6) Turn the Power off.
1) NVRAM Option is adjusted at production line basically.
2) In case Micom (IC601) and NVRAM (IC603 ; EEPROM) is replaced, be sure to set the corresponding ooption number of the repaired
model. (If the option is not set, the unit is not operated.)
ENTER : SAVE
01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16
Fig. 5-17
ENTER : SAVE
01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16
Fig. 5-18
How to identify the Type
Type
Assy-Cylinder Capstan Motor VR501
ALPS SEM Sankyo SEM Be None
A •• •
B •••
C •• •
D •• •
E •••
F •••
G •••
H •••
MODEL TYPE OPTION NUMBER
W-603 A 2, 3, 6, 8, 9, 12, 16
B 2, 3, 6, 8, 9, 12
C 2, 3, 6, 8, 12, 16
D 2, 3, 6, 8, 12
E 2, 3, 6, 9, 12, 16
F 2, 3, 6, 9, 12
G 2, 3, 6, 12, 16
H 2, 3, 6, 12
<Table 5-2>