3-10 MP/8 V.34: Getting Started
Table 3.4S-Registers Stored in NVRAM
Factory
NVRAM S-Register Options Setting
S0 Sets number of rings for Auto Answer* 1
S1 Counts number of rings 0
S2 Escape code character 43
S3 Carriage Return character 13
S4 Line Feed character 10
S5 Backspace character 8
S6 Dial wait-time, sec. 2
S7 Carrier wait-time, sec. 60
S8 Dial pause, sec. 2
S9 Carrier Detect time, 1/10th sec. 6
S10 Carrier loss wait-time, 1/10th sec. 7
S11 Tone duration, spacing, msec. 70
S12 Escape code guard time, 1/50th sec. 50
S13 Bit-mapped functions** 0
S15 Bit-mapped functions** 0
S19 Inactivity/hang up timer 0
S21 Break length, 1/100th msec. 10
S22 XON character 17
S23 XOFF character 19
S24 Pulsed DSR duration, 2/100th sec. 150
S25 DTR recognition time 5
S26 RTS/CTS delay time, 1/100th sec. 1
S27 Bit-mapped functions** 0
S28 V.32 handshake time, 1/10th sec. 8
S29 V.21 handshake time, 1/10th sec. 20
S33 Bit-mapped functions** 0
S34 Bit-mapped function s** 0
S38 Disconnect wait time, sec. 0
S41 Allowable remote login attempts 0
S42 Remote Access ASCII character 126
S43 Remote guard time, 1/50th sec. 200
S44 Re-establish leased-line connect, sec. 15
S51 Bit-mapped functions** 0
S53 Bit-mapped functions** 0
S54 Bit-mapped functions** 0
S55 Bit-mapped functions** 0
S56 Bit-mapped functions** 0
S57 Bit-mapped functions** 0
S58 Bit-mapped functions** 0
*DIP switch 5 must be OFF (default). May not be less than 1; available for
programming a higher value where required.
** Bit-mapped registers have up to eight functions. See descriptions later in
this appendix
To Next Page
Loading...