Totalcomp TRWS Series - Section 11 Error Code

TRWS indicator user’s manual
SECTION 11 ERROR CODES
ERROR
CODES
DESCRIPTION
RESOLUTION
- - - - -
Over range
Remove weight from the scale.
If the problem persists contact your dealer
Totalcomp Inc.
Err 4
Zero Setting Error
The scale was outside the normal zero setting
range either when it was turned on or when the
ZERO key was pressed.
Remove weight from the scale and try again.
Use the TARE key to set the display to zero value.
If the problem persists contact your dealer
Totalcomp Inc.
Err 6
A/D out of range
The values from the A/D converter are outside the
normal range. Remove weight from the scale if
overloaded; make sure the pan is attached.
Indicates the load cell or the electronics may be
faulty.
If the problem persist contact your dealer
Totalcomp Inc.
-17-