7. Repeat Steps 2 through 6 to program the remaining
schedule days. The Copy Previous Day button can be
used to copy the previous day's schedule if the sched-
ules are the same.
8. After all the times and set points for each day have
been entered, press the End button to finish entering
the schedule.
NOTE: The thermostat will continue to follow the sched-
ule until a new one is entered. The schedule may need to
be updated for different seasons or prolonged changes in
temperature.
Overriding the Schedule -The schedule can be
overridden in 3 ways: the Hold button can be pressed to lock in
the current temperature setting, the Up or Down buttons can be
pressed to change the desired temperature, or the Occupied
button can be pressed to change the unoccupied set points to
OCl. The thermostat will use new set point until the next
scheduled time period starts. Once the HOLD button is
pressed, the HOLD will last indefinitely until the HOLD but-
ton is pressed again. The occupied ovenide can be used to
force the thetmostat into Occupied mode.
Display Outdoor-Air or Leaving-Air Tempera-
ture -When the Up and Down buttons are pressed at the
same time, the display will show the temperature of the sensor
wired to the thetmostat. The temperature is displayed for 4 sec-
onds with the letters "od" or "LA" (outdoor sensor or leaving
air sensor, respectively). The display then returns to normal. If
a sensor is not connected, the thennostat has been configured
for use with a remote room sensor, or the reading is out of
range, then "--" is displayed.
The valid temperature range for the outdoor-air sensor is
-38 to 145 F. The valid temperature range for the leaving-air
sensor is -38 to 145 F.
Fig. 1 -Thermostat Liquid Crystal Display
IV nt:ut:1 rlL-It:n
Fig. 2 -Thermostat Display and Programming Buttons
1
To Next Page
Loading...
