To Next PageTo Next Page
Need help?Do you have a question about the TOTALINE TotalTouch P286-1600 and is the answer not in the manual?
General| Backlight | Yes |
|---|---|
| Hold Feature | Yes |
| Filter Change Alert | Yes |
| Battery Indicator | Yes |
| Temperature Range | 45°F to 90°F (7°C to 32°C) |
| Power Source | Battery |
| Display | LCD Touchscreen |
| Programmable | 7-day programming |
| Type | Programmable Thermostat |
| Compatibility | Multi-stage heating and cooling systems |
Anticipator control is used to turn off the heating equipment before the room temperature actually reaches the cut-out point.
The air temperature at the thermostat at which it initiates action of heating/cooling equipment.
The air temperature at the thermostat at which it terminates action of heating/cooling equipment.
Cycle rate is the frequency that heating or cooling equipment is turned on during a certain period of time.
The difference between the cut-in and cut-out points as measured at the thermostat.
A thermostat with the capability of automatically adjusting temperature set point to pre-selected settings.
The automatic alteration of the thermostat control point(s) by means other than manually changing the temperature set point.
The desired temperature setting on an electromechanical or electronic thermostat.
Wiring diagram for connecting the control card to a single air conditioning unit.
Wiring diagram for connecting the control card to a unit with one air conditioner and one heating system.
Wiring diagram for connecting to a unit with one AC and two heating stages.
Wiring diagram for connecting to a unit with one AC and a two-stage furnace.
Wiring diagram for connecting to a heat pump system.
Wiring diagram for connecting to a heat pump with one heating stage.
Interpreting the status of the COMM indicator light for connection and power issues.
Returns to the Home Page from within Advanced Settings.
Option to enable or disable Daylight Saving Time adjustments.
Reminder for air filter changes based on fan run time.
Setting HVAC system consumption parameters for energy tracking.
Configuring PIN protection for thermostat access and changes.
Setting custom messages to display at programmable intervals.
