8. Place the cover (with the o-ring attached) over the top of the tank.
Fig. 8
Fig. 8
9. Screw the lid onto the top of the tank. Make sure that it is secure,
or the filter will leak. Fig. 9
Fig. 9
10. Connect the UV clarifier plug into a properly grounded electrical
outlet. Fig. 10
Fig. 10
11. Wait several seconds for the light to turn on then check the
indicator light to verify if the light is functioning correctly.
Fig. 11
NOTE: This clarifier has a safety feature that only allows the UV
light to turn on if the lamp holder is fully seated into the
lamp housing.
Fig. 11
To Next Page
Loading...