Totem CLASSIC - Maintenance and Record Keeping

6
Maintenance record table
Date
Chimney sweeping
Cleaning runners
Lubricating chains and pinions
Cleaning filters and grilles
Checking gasket condition
Work carried out by
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
………………
r r r r r
………………………………………….. ……………..
Cleaning the cast iron grate Use a wire brush then rub with
household oil to make it shine. s
2.7.3 Maintenance and Chimney Sweeping
Maintenance
The appliances must be checked at least once a year and repaired if necessary by a qualified
professional.
The chimney connectors must always be maintained in good working order, their maintenance must
be carried out at least once a year. The fresh air ducts must always be maintained in
good working order. Clean the outside grille allowing fresh air intake (leaves, dust…) at
the start of the heating season and check it periodically throughout the period of use.
Twice a year, vacuum any dust and soot which have collected in the slides on both
sides of the door. Lubricate the bearings of the door on each side with heat-resistant
oil. To do so, completely lower the door and access the bearings via the inspection
grille. Avoid greasing the door guide rails. Carry out these operations
twice a year.
Clean the dust filters and grilles of the hood twice a year.
Clean the inside of the installation using a vacuum cleaner or brush in order to eliminate any dust
deposits causing carbonization of dust (dirt around the hot air outlets and on the ceiling) at the start
of the heating season and once during the heating season.
Check the condition of the door gaskets. Replace them if necessary.
Spare parts
If you wish to replace parts, broken glass or worn gaskets, contact your fitter, providing
the references for your fireplace.
Chimney sweeping
By chimney sweeping, we mean cleaning by direct mechanical action to the inside wall
of the chimney flue in order to remove soot and deposits to prevent these from
catching fire, ensuring that the flue is clear over its entire length.
Remove the reflectors from the appliance before chimney sweeping the flue.
Chimney sweeping of the installation at least twice a year, including once during the
heating season by a qualified professional company.
A certificate must be issued by the contractor after the work has been complete.
2.8 Maintenance record
Model
Date installed
Contact details of installater
Name
Address
Telephone no.
…………………………………………………….
……………………………………………………..
…………………………………………………….
…………………………………………………….
…………………………………………………….
…………………………………………………….
Flue after chimney
sweeping
Flue before
chimney sweeping