8 | Maintenance
8.1 General Guidelines/Overview
To maintain the full functionality of your kickscooter for a long time, it is necessary to carry out the
maintenance as prescribed with correctness and professional skills.
After each routine maintenance operation, a check on the perfect functioning of all the controls is
mandatory.
This manual does not detail information regarding disassembly and extraordinary maintenance, as
these operations must always and exclusively be carried out by the Assistance Service personnel.
The Assistance Service is able to provide all the information and respond to all requests to take care
of and keep your kickscooter perfectly efficient.
If non-original parts are fitted, the guarantee becomes invalid!
8.2 Maintenance and daily checks
8.2.1 Labels check
Check the legibility and presence of the CE plate affixed to the body of the kickscooter.
8.2.2 Checking the battery charge
The battery charge level is indicated by the small horizontal LEDs located at the bottom of the
display.
8.2.3 Wheel check
Check the condition of the tread, the rim and the attachment of the rims to the hubs.
If you need to replace the wheels, contact the After-Sales Service.
8.2.4 Brake operation check
The disc brake must be adjusted in such a way as to ensure effective braking and at the same time
the control lever must have a proper space to modulate the braking: in other words, the brake must
not be too slow or too tight.
8.2.5 Fine adjustment of the brake
Disc brake adjustment is made via the caliper adjustment screw.
8.3 Maintenance and weekly checks
8.3.1 Washing and cleaning
Cleaning the kickscooter is not only a matter of decorum, but also allows you to immediately detect
any defect in it. In order not to damage or compromise the operation of the various components,
especially the electrical parts, cleaning must be carried out taking certain precautions. It is absolutely
forbidden to direct jets of pressurized water towards the electrical parts, the motor and the battery,
for which washing with a sponge is recommended. Before starting to use the kickscooter, dry
completely with low pressure compressed air and check that there is no residual moisture left on the
electrical components.
8.3.2 Checking the frame and bolts
The supporting frame of the kickscooter and the welds must be free of visible defects such as:
cracks, deformations, incisions, corrosion, etc.
Make sure all kickscooter bolts are tight, especially check that the handlebar stem is tight.
8.4 Maintenance and monthly checks
8.4.1 Control of circuits and electrical components
Check the condition and fastening of the battery cables: the jacket of the visible electric cables must
be in good condition and the terminals must be well tightened and not corroded.
Risk of injury
During all maintenance work, follow the appropriate safety measures.
All maintenance operations must be carried out with the kickscooter turned off
and resting on a stable surface.
Negative check
• If even one check is negative, DO NOT RIDE the kickscooter.
• Immediately take all measures to carry out an adequate repair, and if
necessary, contact the After-Sales Service.
31 32
DANGER
WARNING
To Next Page
Loading...