Totem LYNX - Kickscooter Description; General Kickscooter Description

4.1 Identification plate
Follow the APP instructions to learn to drive safely. Make sure that the plate is perfectly legible. If
not, apply for a new one after requesting it from TO.TEM.
4.1.1. CE Marking
The following data is shown on the CE plate applied to the kickscooter:
– Name and address of the manufacturer;
– Typology;
– Serial number;
– Template;
– Year of construction;
– Weight (in Kg);
– Maximum load (in Kg);
– Maximum speed (km/h);
– Maximum autonomy (km);
– Battery voltage and capacity (in V/Ah)
– Motor power (in W).
You can find below an example of the identification plate.
4.1.2. Declaration of conformity
The declaration of conformity signed by the manufacturer is attached to this manual.
4.2 General Description
LYNX kickscooter is a three-wheeler vehicle (double rear wheel). For its driving it is equipped with a
handlebar connected via a stem to the front steering wheel. The driver remains standing on the
platform located on the frame between the front wheel and the rear wheels, propulsion is given by
the electric motor connected to the front wheel, powered by the rechargeable battery located
inside the steering column; the start from a standstill is always pushed with the foot not resting on
the platform, then it is possible to accelerate the electric motor to regulate one's speed.
The throttle control is a lever to be operated with the thumb on the right handlebar, while the front
disc brake is operated with a mechanical lever on the left.
The electric scooter is designed and built to be used outdoors, on smooth floors (asphalt, concrete,
etc.) within private areas and courtyards.
It can be used in built-up areas according to the provisions of the traffic regulations and the specific
regulations in force.
The use of a helmet and protective equipment while driving is recommended.
The front pipe can be folded onto the platform to reduce bulk during transport.
On the handlebar there are the on/off button, the turn indicator selector and the display for viewing
the vehicle operating parameters.
The kickscooter is equipped with a front light, a position and stop light and led turn indicator lights
on the rear of the kickscooter.
On the front pipe, where the battery is contained, there is the socket for charging the battery.
4 | Description of the kickscooter
Incorrect and unintended use
The kickscooter is designed and built for this specified use; a different use and
non-compliance with the technical parameters set by the manufacturer may
represent a dangerous condition for users.
11 12
DANGER