The “up” and “down” buttons select the level of motorized assistance, with level 1 being the least power
and level 5 being the most power.
By cycling through the “Mode” button functions, you can alternate the display to show the total mileage
odometer, the current trip odometer, and the remaining range based on the current battery level. The
“Range” function is affected by many variables and should not be interpreted as an absolute figure. For
example, if the first half of your trip is on flat terrain, but the second half is on a steep grade, the range
will diminish.
In the “Trip” mode, you can reset the Trip odometer by holding the “up” and “down” buttons together.
The total odometer mileage can’t be reset without a special dealer tool.
By pressing and releasing the “Mode” button, then pressing and holding the “down” button, you will
enter the Walk Assistance Mode. Release the “down” button to exit the Walk Assistance Mode.
Settings: By holding the “Mode” and “down” button together for 3 seconds, you can enter the Settings
interface. Once in the Settings interface, using the “up” and “down” buttons you can select between
different settings to adjust. Pressing the “mode” button again then allows you to change the Walk
Assistance speed, switch between MPH and Km/h, and adjust the backlight setting brightness.
“blG” indicates the backlight brightness, select between 60%, 80%, or 100%
“PSH” indicates the Walk Assistance Speed, select from levels 3 to 6.
“Unit” indicates the unit of measurement for speed, select from MPH or Km/h
Note: the “dPs, dPb, CLS, and CLb” settings are for the display and controller software and should not be
changed.
Troubleshooting
Having trouble? Please reach out to the TotemUSA Support Team so that we may assist you. We offer a
comprehensive Frequently Asked Questions page, as well as a detailed trouble-shooting guide on our
website for each Totem electric bike model.
Error Codes – Your smart display communicates with the bike’s controller to record any electronic or
mechanical errors. These errors are indicated with a wrench icon on the display and a corresponding
code. The bike is equipped with several safety mechanisms that disable the electric function of the bike
and protect the rider when something isn’t right. If you see the gear icon and a corresponding error
code consisting of numbers and letters, please reach out to us for assistance. Alternatively, you can visit
our website for the detailed trouble-shooting guide.
To Next Page
Loading...