Toto EcoPower Automatic Faucets - Care & Cleaning; Periodic Maintenance

7
ENGLISH
INSTALLATION PROCEDURE
Testing After Installation
Open
Close
Stop Valve
ill. 1
dna sevlav pots eht ta ylppus retaw eht no nruT
inspect all the connections for any leaks (see ill. 1).
Place hand under the sensor to activate.
For 10 sec model: water will stop after 10 seconds
while your hand is under the sensor.
Water will stop when you remove your hand.
CARE & CLEANING
PERIODIC MAINTENANCE
gninaelc nehw Do not scratch the sensor IMPORTANT!
the spout (see ill. 2).
Avoid using any cleaning materials that may scratc eht h
spout surface.
Never use polishing powder, detergent that include s
coarse particles, thinners, benzene, acids, alkaline
detergents, or nylon scrub brushes, as they can damage
the surface of the spout.
To safely clean the surface, wipe it using a dampene tfos d
cloth with diluted dishwashing detergent and dry it with
another soft cloth. If this does not adequately clean the
surface, wipe the area with a neutral detergent and wet cloth.
ill. 2
Sensor Area
Outlet
Check your faucet at least once a month for the following potential problems and to do the
following maintenance procedures:
Inspect for Leakage
Check all water connections for signs of leakage.
Tighten the Spout
If the spout is loose, tighten the hexagonal nut underneath the spout for deck-mounted
models.
To tighten the Helix Wall-Mounted Spout:
1. Unscrew the escutcheon, tighten the three screws securing the mounting bracket to the
wall.
2. Reinstall escutcheon.
To tighten the Gooseneck Wall-Mounted Spout
1. Turn off the water supply at the stop valves.
2. Disconnect the spout connecting hose and sensor connector
from the controller.
3. Remove the spout from the mounting bracket by removing the set screw on the bottom
of the spout base.
4. Tighten the set screw on the back of the spout, then reinstall the spout on the mounting
bracket.
5. As required, ensure the set screw on the mounting bracket and mounting nuts behind
the sink/wall (refer to “Install the Spout” section) are tight.
For 20 sec model: water will stop after 20 seconds.
Spout and Sensor