14
■ Do not touch around the exhaust
outlet with bare hands.
The push lever and nose will
become hot and get heated up
after prolonged or rapid use.
■ Do not allowed push and pull
push lever with hand, otherwise
will caused accidental firing,
hurt someone .
■ Explosion and fire hazard Keep
away from sunshine and from
temperature exceeding 120°F
(50°C).
■ Keep away from ignition source.
■ No smoking.
WARNING
■ NEVER point tool at yourself or
others in work area.
■ Keep fingers AWAY from
trigger when not driving nails
to avoid accidental firing.
■ Use outside or well- ventilated
area.
■ Do not inhale its contents.
■ Do not use the electrical cord if
damaged. Have it repaired
immediately .
■ Never place your face, hands
or feet closer than 8 inches
(200 mm) from firing head when
using.
■ Do not drive nails on the top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
■ Do not drive nails into thin boards or near corners
and edges of workpiece. Nails can be driven
through or away from workpiece and hit someone.
■ Never drive nails from both sides of a wall at
the same time. Nails can be driven into and
through the wall and hit a person on the
opposite side.
■ Never use Nailer which is defective or operating
abnormally.
■ Do not use Nailer as hammer.
■ Disconnect battery and fuel cell from Nailer
when:
it is not in use;
leaving work area;
moving it to another location;
handing it to another person.
■ Be careful of unwanted fastener.
If the nailer can not normal driving nail at the
temperature below 23°F (-5°C), downward push
lever against to the workpiece, quick press
120°F MAX
(50 )℃
Removing the nails:
(1) Pull the feeder knob backward to leave the
nails a little distance, press the knob of the nail
feeder (see chart e).
The nails fall back on end of magazine catch
location (see chart f) as itself action of gravity.
nail feeder let it replacing .
Chart e
(2) Midfinger press the catch, let the nails drop into
palm of the hand(see chart g).
NAILER OPERATION
Read section titled “SAFETY”.
DANGER
■ Operators and others in work
area MUST wear safety glasses
with side shields which conforms
to ANSI Z87.1 specifications.
■ Never use in presence of flammable liquids
or gases.
Feeder Knob
Nail Feeder
Catch
Chart f
Chart g
To Next Page
Loading...