18
Operator troubleshooting
CHECK METHOD CORRECTION
Nailer operates,
but no nail is driven.
Use only recommended nails.
Clear a jam nails.
Check for a jam .
Check for a jam nails.
Check for proper nails.
Clear a jam.
Check function of nail feeder . Clean and lubricate.
Ribbon spring weakened
or damaged?
Replace Ribbon spring.
Check if the driver blade
piston is down or not.
Push the driver blade with a
slotted-head screwdriver, and put
back the piston to the highest position.
Check for proper nails.
Check function of nail feeder.
Ribbon spring weakened or damaged.
Nail feeder weakened or damaged?
Use only recommended nails.
Clean and lubricate.
Replace Ribbon spring.
Replace nail feeder.
Skipping nails.
Intermittent feed.
Check for returning of piston.
Check for moving of piston smoothly. Replace piston assembly.
Too low temperature, warm up
fuel cell under 50 (120 ).℃℉
Nail jam.
Driven nail is bent.
Replace piston assembly.
Use only recommended nails.
Nail feeder worn or damaged?
Check for proper nails.
Driver blade worn?
Replace nail feeder.
Push lever bent?
Check push lever's moving track, debris?
Replace push lever.
Clean the foreign body.
The operation of the
push lever not smooth.
Too low temperature, warm up
Pull the trigger all the way.
Check for returning of piston.
fuel cell under 50 (120 ).℃℉
Check fuel cell, insufficient? Exchange it with a new fuel cell.
Check spark plug wire, worn out?
Contact TOUA for replacement
to the spark plug.
High pressure cap joint insert
Check spark plug, grease or debris?
Check high pressure cap joint insert
to the spark plug.
Clean the foreign body.
Check filter, clogged? Cleaning or Contact TOUA for
replacement.
in the magazine.
Load more nails(more than 4 nails)
Note the color of the light indicator.
Magazine empty.
If red: charge the battery.
If green: Contact TOUA for replacement.
Inspect if the battery temperature within
Wait the battery temperature as
Insert all plugs and ensure the
the normal range then to charge.
and the battery pack Insert in place.
require range 50°F( 10°C)～104°F (40°C).
Check if all joints are inserted
battery pack insert in place.
Utility voltage not nearly of rated Select and use correct utility voltage to
voltages shown on adapter nameplate.
charge. If also can not charge, contact
TOUA for replacement.
drive a nail or operation
Fan is working, light indicator
shows GREEN yet it doesn't
unstable.
Fan does not operate
when push lever is pressed.
Unable to charge battery
PROBLEM
The battery pack loosen after inserted
in the charger base.
Contact TOUA for replacement.
To Next Page
Loading...