Why tousek Gate Opener has no reaction after emitting a command?
If your tousek Gate Opener doesn't react when you send a command, it could be due to a couple of reasons: * The main voltage might be missing, or the fuse F1 could be defective. Check the main voltage and the condition of fuse F1. * The display might show an error related to the stop button. Ensure the stop button is correctly connected or bridged.
What to do if tousek Gate Opener opens but does not close?
If your tousek Gate Opener opens but then fails to close, here are a couple of potential causes and how to address them: * **Photocell Interruption:** The photocells might be obstructed or misaligned. Check their positioning and ensure they are functioning correctly. * **AR System Activation:** The AR (Automatic Reverse) system may have been triggered. Verify the force and sensor adjustments.
How to solve safety sensing edge 1 or 2 actuated on tousek Gate Opener?
If safety sensing edge 1 or 2 is activated on your tousek Gate Opener, it indicates an issue with the safety mechanisms. This is likely due to incorrect adjustment of the safety sensing edges. To resolve this, remove any obstacles that might be triggering the safety edge. You can also use the status display to control the function and identify the problem.
What to do if tousek Gate Opener control relays switch but motor does not run?
If the control relays in your tousek Gate Opener are switching, but the motor isn't running, the connection between the motor and the control unit may be defective. Check the supply lines to ensure they are properly connected and functioning.
Why tousek Gate Opener radio receiver has no reaction?
If the radio receiver of your tousek Gate Opener isn't responding, consider these possibilities: * The radio receiver might be plugged into the wrong connector. Ensure it's properly installed according to the instructions. * There might be no antenna connected, or the antenna connection is faulty. Check the antenna connection. * The radio transmitter may not be programmed. Program the handheld transmitter.
What does error message „no learned way“ mean on tousek Gate Opener?
The error message "no learned way" on your tousek Gate Opener indicates that the sensors or motors are not correctly connected, or the condenser is not connected. Check the connections to ensure they are properly configured.
General| Brand | tousek |
|---|---|
| Model | ST 61 |
| Category | Control Unit |
| Language | English |
To Next Page
