Tower Hobbies T113003BLG - Cleaning and Care Instructions; Emptying the Dust Tank; Cleaning the Unit Body; Cleaning the Roller Brush

12
Emptying the Dust Tank:
1. To empty the dust tank, begin by pulling the release button on the bottom of
the tank to separate it from the main unit.
2. Pull the inlet lter out of the dust tank and shake the tank’s contents into a
dustbin
3. Once you have emptied the dust tank, t the lter back into place and afx
the dust tank back onto the body of the unit until it clicks into place. Use the
recessed area at the edge of the tank as a guide for how to position the tank
when re-tting it into place.
Cleaning the Unit Body:
1. Before cleaning the unit body, ensure the unit is disconnected from the mains
supply and not in operation.
2. Use a damp cloth to clean the unit body. Never use any abrasive cleaning
materials or solvents, as these could cause damage to the surface of the unit.
WARNING! DO NOT allow any liquids into the unit, as this could cause damage to
the electrical components and cause it to malfunction.
Cleaning the roller brush :
1. To clean the roller brush, rst insert a coin or another small object into the
brush lock slot located on the underside of the brush, then turn it counter-
clockwise to loosen the roller brush within.
2. Lift the lock slot cover and pull out the roller brush.
3. Remove uff, hairs and other dirt from the brush, then t it back into place.
4. Close the lock slot cover and rotate it clockwise to tighten and secure the roller
brush in place.
Storing the Appliance:
1. When not using the vacuum for extended periods of time, store the unit in a
cool, dry place, preferably inside its original packaging.
8 - Cleaning & Care