9
Cleaning & Care
Note: Ensure the appliance is turned off and unplugged from the mains before emptying the dust
tank.
Emptying the Dust Tank:
Hold the unit over a bin and press the dust tank release button. Empty the contents of the dust
tank. Once empty, push the cover back into place until there is an audible click.
Cleaning the Filter:
1. Press the filter release button to open the filter housing.
2. Remove the filter from the dust tank.
3. Tap it lightly against a dustbin or sink to remove particles.
4. Wash the filter regularly to ensure maximum suction performance. Allow to dry thoroughly
before replacing it into the unit.
Cleaning the Unit Body:
1. Before cleaning the unit body, ensure the unit is disconnected from the mains supply and not
in operation.
2. Use a damp cloth to clean the unit body. Never use any abrasive cleaning materials or solvents,
as these could cause damage to the surface of the unit.
WARNING! DO NOT allow any liquids into the unit, as this could cause damage to the electrical
components and cause it to malfunction.
Cleaning the Interchangeable floor head brush bar:
Remove the brush bar.
Remove fluff, hairs and other dirt from the brush.
Refit the brush bar.
Clearing Blockages:
If the dust tank is overfilled, the filter is clogged up, or the vacuum picks up a larger piece of debris,
the vacuum may become clogged.
Should this occur, carry out the following steps to unclog the vacuum:
1. Check the dust tank and empty it if necessary.
2. Check the filter for any debris and rinse it under running water if necessary, as detailed in the
sections above.
3. Detach any attachments from the unit and check for blockages.
Storing the Appliance:
1. Store the appliance in a cool, dry place, preferably inside its original packaging, and out of the
reach of children.
To Next Page
Loading...
