’06 MATRIX_U (L/O 0508)
292
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
! To prevent burning yourself, do not
replace the light bulbs while they
are hot.
! Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toy ot a d e al er.
Light bulbs
Bulb
No.
W Type
Headlights (low) 9006
55
A
Headlights (high) 9005
65
B
Front fog lights 9006 55 A
Parking, front
side marker and
front turn signal
lights
1157NA 27/8 C
Stop/tail and rear
side marker
lights
7443 21/5 D
Rear turn signal
lights
— 21 E
Back−up lights 921 16 D
High mounted
stop light
921 16 D
License plate
light
— 5 D
Replacing light bulbs—
To Next Page
Loading...
