EasyManua.ls Logo

Toyota 2008 4Runner - Page 182

Toyota 2008 4Runner
492 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
167
Fourwheel drive models
4.0 L V6 (1GRFE) engine
Multimode drive control
switch knob at H2” or “H4”
“3” 146 km/h (90 mph). . . . .
“2” 100 km/h (62 mph). . . . .
“L” 58 km/h (36 mph). . . . . .
Multimode drive control
switch knob at L4”
“3” 57 km/h (35 mph). . . . . .
“2” 39 km/h (24 mph). . . . . .
“L” 22 km/h (14 mph). . . . . .
4.7 L V8 (2UZFE) engine
Fourwheel drive control
switch knob at H4”
“3” 146 km/h (90 mph). . . . .
“2” 100 km/h (62 mph). . . . .
“L” 58 km/h (36 mph). . . . . .
Fourwheel drive control
switch knob at L4”
“3” 57 km/h (35 mph). . . . . .
“2” 39 km/h (24 mph). . . . . .
“L” 26 km/h (16 mph). . . . . .
! Do not continue hill climbing or
hard towing for a long time in the
“3”, 2” or L” position. This may
cause severe automatic transmis-
sion damage from overheating. To
prevent such damage, 4” position
should be used in hill climbing or
hard towing.
(e) Backing up
1. Bring the vehicle to a complete stop.
2. With the brake pedal held down with
your foot, shift the selector lever to the
“R” position.
NOTICE
Never shift into reverse while the ve-
hicle is moving.
Vehicles with rear view monitor system
When the selector lever is shifted into “R”
position with the engine switch in the
“ON” position, rear view monitor system
will activate. For instructions, see “Rear
view monitor system” on page 312 in Sec-
tion 110.
(f) Parking
1. Bring the vehicle to a complete stop.
2. With the brake pedal pressed down,
fully depress the parking brake pedal
to apply the parking brake securely.
3. With the brake pedal pressed down,
shift the selector lever to the “P posi-
tion.
CAUTION
Never attempt to move the selector
lever into “P position under any cir-
cumstances while the vehicle is mov-
ing. Serious mechanical damage and
loss of vehicle control may result.
If the automatic unlocking operation linked
with the shift position is set, all the side
doors and back door are automatically un-
locked when the selector lever is moved
to the “P position with the engine switch
is in the “ON” position. For details, see
“—Automatic door locking and unlocking
functions” on page 25 in Section 12.
07 12.25

Table of Contents

Related product manuals