305
Operate the multi−information display
with the engine switch on.
When the engine switch is turned to “ON”,
the last previously used mode displayed
just before the engine switch is turned off
will appear.
If the electrical power source has been
disconnected from the multi−information
display, the display will automatically be
set to the initial mode.
CAUTION
Do not adjust the display while the
vehicle is moving. Be sure to adjust
the display only when the vehicle is
stopped.
CY19001
To reset the hour: Push the “H” button.
To reset the minutes: Push the “M” button.
If quick adjustment to a full hour is de-
sired, push the “:00” button.
For example, if the “:00” button is de-
pressed when the time is between
1:01—1:29, the time will change to 1:00.
If the time is between 1:30—1:59, the
time will change to 2:00.
The engine switch must be in the “ACC”
or “ON” position.
If the electrical power source has been
disconnected from the clock, the time dis-
play will automatically be set to 1:00 (one
o’clock).
CY19082
The displayed temperature ranges from
−30!C (−22!F) up to 50!C (122!F).
The engine switch must be in the “ON”
position.
If an abnormality exists in the connection
of the outside air temperature sensor,
“−−!C” (“−−!F”) will appear on the display.
If “−−!C” (“−−!F”) appears on the display,
contact your Toyota dealer.
There may be a case that “−−!C” (“−−!F”)
appears momentarily when the engine
switch is quickly turned to “ON”. It is
normal if it goes out soon.
07 12.25
—Before using the
multi−information display
—Clock
—Outside temperature display
(air conditioning system
without “DUAL” button)
To Next Page
Loading...
