185
To turn on: Briefly push the “VSC OFF”
switch once again.
The “VSC OFF” and slip indicator lights
will go off.
If the engine is turned off while the “VSC
OFF” and slip indicator lights are on and
then restarted, the indicator lights will turn
off automatically.
When you briefly push the “VSC OFF”
switch, turn off the vehicle stability control
system. See “Traction control system” on
page 175 in this Section.
The “VSC OFF” and slip indicator lights
come on for a few seconds when the
engine switch is turned to “ON”. If the
indicator lights do not come on when the
engine switch is turned to “ON”, contact
your Toyota dealer.
CAUTION
Do not drive with the vehicle stability
control system continuously turned
off.
CY16074
“VSC OFF” warning light
! Vehicle stability control system
! Traction control system
(two−wheel drive models)
! Active traction control system
(four−wheel drive models)
! “AUTO LSD” system
(two−wheel drive and multi−mode four−
wheel drive models)
! Downhill assist control system
(four−wheel drive models)
! Hill−start assist control system
This light flashing warns that there is a
problem somewhere in the following.
The light will come on when the engine
switch is turned to “ON”, and will go off
after about a few seconds.
The light may come on for 60 seconds
after the engine switch is turned to “ON”.
It is normal if they go out after a while.
Depressing the brake pedal repeatedly
may turn on the light. It is normal if they
go out after a few seconds.
If the light flashes while driving, the ve-
hicle stability control system does not
work. However, as normal braking oper-
ates when being applied, there is no prob-
lem to continue your driving.
In the following cases, contact your Toyota
dealer:
! The warning light does not come on
after the engine switch is turned to
“ON”.
! The warning light remains on after the
engine switch is turned to “ON”.
! The warning light flashes while driving.
07 12.25
To Next Page
Loading...
