192
“LO” (low) mode—
The vehicle height is about 20 mm (0.8
in.) lower at rear than the “N” mode
height.
This mode allows you easy access to the
vehicle (getting in and out) and easy load-
ing and unloading operation.
This mode is available when the vehicle
speed is under about 12 km/h (7 mph).
NOTICE
Use the “LO” mode when the vehicle
is stopped. Otherwise, when the ve-
hicle speed exceeds about 12 km/h (7
mph), “N” mode is selected automati-
cally. So be careful when you drive in
any place where the overhead height
is limited.
(b) Vehicle height mode changing con-
dition
To change the vehicle height, it is neces-
sary to meet the following conditions.
! The engine should be running.
! The height control “OFF” indicator light
should go off.
! When selecting a mode, there is a ve-
hicle speed limit. Refer to the following
table.
Yes = The mode c an b e selec t ed.
No = The mode cannot be selected.
“LO”
mode
“N”
mode
“HI”
mode
Under about
12 km/h
(7 mph)
Yes Yes Yes
Under about
30 km/h
(19 mph)
No Yes Yes
About
30 km/h
(19 mph) or
over
No Yes No
In the following cases, the rear height
control suspension will not operate.
! The underbody of the vehicle has
touched the surface on bumpy roads.
! The area around the rear suspension
is coated with ice.
If the vehicle is moved to its usual loca-
tion or the ice is removed and the height
select switch is pressed, the vehicle
height control cannot be operated. In this
case, turn off and restart the engine, then
push the control switches.
07 12.25
To Next Page
Loading...
