9
10
CALLING BY VOICE RECOGNITION
DIAL BY NAME
Press
on the steering wheel. After
the beep say, “Call <name>*.” Please
say the name exactly as it is entered in
your phone.
step
1
Quick Tip - If you know your next command, you
can press
at any time to interrupt the prompt.
Speak your command after the beep.
Verify the contact name, and then
dialing will begin.
step
2
If you are able to successfully transfer your phone book, you can dial by name using voice recognition.
Please say the name exactly as it is entered in your phone when in the telephone screen. If you have
difficulty pairing your phone, or are unable to transfer your cell phone book, please refer to the cell phone
manufacturer's user guide.
Call is active when is
indicated. To end call, press
on the screen or
on the steering
wheel.
step
3
CALLING BY VOICE RECOGNITION
The system will ask you to verify the
number.
step
2
step
3
Press on the steering wheel. After
the beep say, “Dial <number>.” Say
the phone number digits individually,
without pausing (e.g. “Dial Three, one,
zero, four…”).
step
1
Call will begin dialing.
Call is active when
is
indicated. To end call, press
on the screen or
on the steering
wheel.
step
4
Quick Tip - It is recommended that you reduce
background noise prior to using the Voice
Recognition system. Conversation, high fan speed,
wind noise (open windows), etc., may prevent the
voice recognition system from understanding your
commands.
Quick Tip - If you know your next command, you
can press
at any time to interrupt the prompt.
Speak your command after the beep.
Some Bluetooth
®
equipped cell phones
may or may not show battery or signal strength on the
display.
DIAL BY NUMBER
*NOTE: When saying contact name, be sure to say it
exactly as it is entered in your address book
To Next Page
Loading...
