Toyota 2F - Page 108

8-30
I GNITION SYST EM - Distributor Installation
Fig. 9 . 94
F ig . 9. 95
---
5. Turn the 1gn111on switch to ON
- Not e -
Do not
cra nk th o st ar t er m otor .
..&. 6
Rotate the distributor body counterclock·
wise until a spa rk jumps between the
points and
tighten the clamp bo ll in that
POSit1on
7 Check the 1gn 1t 1on t1m 1ng at 1dlo speed.
Ign itio n ti mi n g:
7' BTDC/M ax . 950 rpm
8. If necessary. 01 1911 the timing ball with the
painter
by iurning rh e distribut or body.
M a1 k on ftywheel TOC
Fig. 8·88
r
Shaft Slot Ol1ecoon
APPfOA- 22•
[ '' '"
I
Fig. 8- 90
IGNITION SYSTE M - Distributor Insta lla tion
8-3 1
US A FJ SE RIES
SEt
tho No I cylinder 10 TDC/compres-
sion
Set the 011 pump shah slot on the dorec1oon
shown in tho loguie.
8e91n
onsonoon of the dostrobutor wi th the
roto1 pointing
as shown 1 11 the figure.
- N ote -
Align the flange center with tho screw hole
center.
When fully installed. tho rotor should
poinL as shown in the f1guro
I