Toyota 2F - Page 5

1- 2
INTRODUCTION - G en eral R ep air Ins tr uc ti ons
GENERAL REPAIR INSTRUCTIONS
1. Use fender, seat and fl oor covers to keop the car clean and prevent damage.
2. During disassembly, keep parts in order to facilitate reassembly .
3. Before per f orming electrica l work, disconnect the cable from the battery terminal.
4. Always replace cotter pins. gaskets and 0 rings with new ones.
5. When necessary. use a sealer on gaskets to prevent leaks.
6. Carefully observe all specifications for bolt tightening torques. Always use a tor-
que wrench.
7. Use genuine Toyo ta parts.
8. When replacing fu ses, bo sure tho new f use is the correct amperage . DO NOT
exceed the fuse amp rating or use one of a lower rating.
9. If the vehicle is to be jacked up only at the front or rear end. be sure to block the
wheels in order to ensure safety .
1 O. After the vehicle is jacked up, be sure to support it on stands . It is extremely
dangerous to do any work on the vehicle raised on a jock alone. even for a small
job that can be finished quickly .
11 . Use of a special service tool (SST) may be required . depending on the nature of t he
repair . Be sure to use SST where s1>eclfied and follow the proper work procoduro.
A fist of SST ca n be found at the back of this manual.
INTRODUCTION - Ab bre v ia tions Used In Toyota Repair M anuals
ABBREVIATIONS USED IN TOYOTA REPAIR MANUALS
For convenren ce. lhe following abbrovia1ions are used on T oyo1a repair manuals
Abbrevia 1i on
Term
Abbrevia 11 on
Term
---
A/T
Au1oma1ic Transmission
OIS
Ovors120
BDC
Bo11om Dead Cenior
RH
Righi· hand
BTDC
Before Top Dead Conier
RHO
R1gh1 ·hand Drtve
--
EX
Exhau s1
SST
Spe c ial Service T 001
IN
lniake
STD
Standard
--
LH
Lofl- hand
T
T1gh1en1ng Torque
LHD
Loft· hand D rt ve
TDC
Top Dead Cen1or
--
MP
Mul 1ip u rpose
UIS
Undo r size
M IT
M anua l Transm is sion
WI
W 11 h
._
--
OPT
Op lion
WIO
Wl1hou 1
3
I
· I
I