Toyota 2F - Page 89

7 - 12
STARTING SYSTEM - S ta rter
Fig. 7- 33
Fig. 7- 34
Fig. 7-35
Fig. 7- 36
Brush
Measure t he brush length and replace 1f below
1h e limit
Brush leng th :
STD 19 mm
(0. 75 in.)
Limit
10 mm
( 0.3g in.}
Brush Spring
Measure l he brush spri r>g load wi th a pull
scale If the reading is below 1he speci fied
val ue. replace the spring
Tension:
1. 02 - 1. 38 kg
(2.2 -
3.0 lb)
-
Not o -
Tak e the pu ll scale reading at the very ins·
tant th e brush spri ng separates from the
brush.
Brush Holde r
Check the i nsu lation be1ween the 8 brush
ho lder and $ brush hol de r Repai r or repl ace.
1f cont 1nu1ty is indicaled
Drive Lever
Check t he drive lever and spring l or wear.
Rep l ace. if necessary.
Fig.
7-37
,,,
Fig. 7-38
~ '
'
Fig. 7· 39
Fig . 7 - 40
START IN G SYSTEM - Starter
7- 13
Starter Cl utch & Pinion Gear
I. Check the spline tee1 h f or wea r or
damage. Replace.
1f necessary.
2. Check 1 he pinron for smoo 1h movement
~ 3.
Check lhe pinion gea r 1ee1h and 1 he
chamler for wear or damage.
Ro1a1e the pinion. It should turn lr ee in
clockwi se direction but l oc k when 1urned
co un l erc l ockwise.
Magnet ic Switch
1. Push rn the plunger and release it
The plunger should re1urn quickly to rts
ori0 i nal pos111on .