193
Vertical movement gauges: The bubble
on the gauge should be within two marks
from center on both sides.
Horizontal movement gauges: The
triangle mark on the gauge should be
within one mark from the “O” position.
If a gauge reading is not within the accept-
able range, have the aiming adjusted by
your Toyota dealer.
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
Halogen bulbs have pressurized
gas inside and require special
handling. They can burst or shatter
if scratched or dropped. Hold a bulb
only by its plastic or metal case. Do
not touch the glass part of a bulb
with bare hands.
CAUTION
!
NOTICE
Only use a bulb of the listed type.
Light bulbs Bulb
No.
W Type
Headlights
(low beam)
9006 55 A
Headlights
(high beam)
9005 65 B
Front fog light - 55 C
Parking and front turn sig-
nal lights
1157 27/8 C
Front side marker lights 194 3.8 D
Replacing light bulbs—
To Next Page
Loading...
