63
To turn the wipers on, move the lever.
To make the washer squirt, push the
button on the end of the lever.
The key must be in the “ON” position.
The wipers will operate at intervals when
the lever is in the “INT” position. With the
lever in this position, the wipers can be ad-
justed to operate at intervals of 3 to 10 se-
conds depending on the interval adjuster
setting between “S” and “F”.
Also, the wipers will automatically operate
a couple of times after the washer squirts
even with the lever in the “OFF” position.
If the washer does not work, check to see
whether the washer tank is empty. For in-
formation on adding washer fluid, see
“Adding washer fluid” in Chapter 7-3.
In cold weather, warm the windshield with
the defroster before using the washer.
This will help prevent icing, which could
block your vision.
NOTICE
Do not operate the wipers if the
windshield is dry. It may scratch the
glass.
To turn the wipers on, move the lever.
To make the washer squirt, push the
button on the end of the lever.
The key must be in the “ON” position.
If a single wipe is desired in mist, push the
lever to the “MIST” position and release it.
If the washer does not work, check to see
whether the washer tank is empty. For in-
formation on adding washer fluid, see
“Adding washer fluid” in Chapter 7-3.
In cold weather, warm the windshield with
the defroster before using the washer.
This will help prevent icing, which could
block your vision.
Windshield wipers and washer
(intermittent type with interval
adjuster)
Windshield wipers and washer
(mist type)
To Next Page
Loading...
Need help?
General
