EasyManua.ls Logo

Toyota GR Corolla - Page 242

Toyota GR Corolla
420 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
242
6-1. Maintenance and care
NOTICE
Cleaning the exterior lights
Wash carefully. Do not use
organic substances or scrub
with a hard brush.
This may damage the surfaces
of the lights.
Do not apply wax to the sur-
faces of the lights.
Wax may cause damage to the
lenses.
To prevent damage to the
windshield wiper arms
When lifting the wiper arms away
from the windshield, pull the driver
side wiper arm upward first, and
repeat for the passenger side.
When returning the wipers to their
original position, do so from the
passenger side first.
When using a high pressure
car wash
When washing the vehicle, do
not spray the camera or its sur-
rounding area directly with a
high pressure washer. Shock
applied from high pressure
water may cause the device to
not operate normally.
Do not spray water directly on
the radar which is equipped
behind the emblem. Otherwise
it may cause the device to be
damaged.
Do not bring the nozzle tip close
to boots (rubber or resin manu-
factured cover), connectors or
the following parts. The parts
may be damaged if they come
into contact with high-pressure
water.
Traction related parts
Steering parts
Suspension parts
Brake parts
Keep the cleaning nozzle at
least 11.9 in. (30 cm) away from
the vehicles body. Otherwise
resin section, such as moldings
and bumpers, may be deformed
and damaged. Also, do not con-
tinuously hold the nozzle in the
same place.
Do not spray the lower part of
the windshield continuously. If
water enters the air conditioning
system intake located near the
lower part of the windshield, the
air conditioning system may not
operate correctly.
Do not wash the underside of
the vehicle using a high pres-
sure car washer.
Hood vents (if equipped)
The hood vents are covered in
order to protect the engine from
water or foreign matter (dry
leaves, etc.).
Do not remove the covers, as
they are designed to release the
heat from the engine compart-
ment and to drain external water,
such as rain, properly.

Table of Contents

Related product manuals