Toyota GR Corolla - Light Bulbs

304
6-4. Do-it-yourself maintenance
Check the wattage of the light
bulb to be replaced. (P.358)
License plate lights
■ Bulbs that need to be
replaced by your Toyota
dealer
 Headlights
 Parking lights
 Daytime running lights
 Turn signal lights
 Side marker lights
 Front fog lights
 Tail lights
 Stop lights
 Back-up light
 High mounted stoplight
■ LED light bulbs
The lights other than the license
plate lights consist of a number of
LEDs. If any of the LEDs burn out,
take your vehicle to your Toyota
dealer to have the light replaced.
■ Condensation build-up on the
inside of the lens
Temporary condensation build-up
on the inside of the headlight lens
does not indicate a malfunction.
Contact your Toyota dealer for more
information in the following situa-
tions:
● Large drops of water have built up
on the inside of the lens.
● Water has built up inside the
headlight.
■ When replacing light bulbs
P.303
■ License plate lights
1 Remove the light unit.
Insert a flathead screwdriver or
similar into the hole next to the light
and remove it as shown in the illus-
tration.
To prevent damaging the vehicle,
wrap the flathead screwdriver with
Light bulbs
You may replace the follow-
ing bulbs by yourself. The
difficulty level of replace-
ment varies depending on
the bulb. If necessary bulb
replacement seems difficult
to perform, contact your
Toyota dealer.
For more information about
replacing other light bulbs,
contact your Toyota dealer.
Preparing for light bulb
replacement
Bulb locations
Replacing light bulbs