Toyota HDJ100 User Manual

Toyota Land Cruiser 100 Series HDJ100/UZJ100 Lock Up kit instructions
Page | 1
TOYOTA
100 Series LANDCRUISER
HDJ100 and UZJ100
08/2002 – 2007 5 SPEED AUTOMATIC
ON OFF ON Switch
Automatic Low Speed Lock Up and Automatic High Speed Lock Up
TORQUE CONVERTER LOCK UP KIT
AUTOMATIC LOCK UP CONTROLER

Toyota HDJ100 Specifications

General

Air Conditioning	Standard
Central Locking	Standard
Power Windows	Standard
Cruise Control	Standard
Power Locks	Standard
Navigation System	Available (depending on trim level)
Keyless Entry	Available (depending on trim level)
Steering Wheel Controls	Available (depending on trim level)

Summary

Installation Procedure

Step 1: Run Wiring

Details routing the wiring harness and initial power connections.

Step 2: Locate ECU Wires

Instructions for identifying specific wires at the ECU connector.

Step 3: Insert Lockup Controller into Circuit

Instructions for connecting the controller into the vehicle's wiring.

Step 4: Pickup Vehicle Speed Signal

Instructions for connecting the vehicle speed signal wire.

Step 5: Install Controller, Relays, Earth and Resistor

Mounting the controller, relays, earth, and resistor.

Step 6: Switch Installation and Red Wire Connection

Installing the control switch and connecting the red wire to accessory power.

Step 7: Battery Power Feed

Connecting the unit to the vehicle's battery for power supply.

Operation and Usage Guide

High Speed Auto Mode Operation

Low Speed Lock Up Activation

Automatic Mode Operation (Dual Switch)

Low Speed Mode Operation (Dual Switch)