28
(2) Charge by timer
PROCEDURE
1. Push the "TIME SET" button to show
the current time on the display. If the
displayed time is not correct, enter the
correct time with the "H" and "M" but-
tons.
2. Push the "TIME SET" button again to
show the charging start time on the
display. To change the start time, en-
ter the desired start time with the "H"
and "M" buttons.
3. Push the "TIME SET" button again to
show the preheating/precooling start
time on the display. If preheating/pre-
cooling is not needed, proceed to the
next step.
4. Push the "TIME SET" button again.
The display goes out and the timer
setting completes.
5. Push the "TIMER CHARGE" button.
The charger enters the timer charging
mode and the "TIMER CHARGE" light
comes on.
6. Insert the charge coupler within 3 min-
utes from step 5.
Charging starts and stops automatically
when the traction batteries are charged.
To cancel the setting, push the "TIMER
CHARGE" button again.
If you insert the charge coupler after the
set start charging time, charging starts at
the set time of the next day.
Do not remove the charge coupler until
charging is completed. Although the mes-
sage on the indicator panel on the char-
ger remains the same as charging, the
timer’s charge mode on the vehicle is
cancelled.
If the charge coupler is pulled out, once
put it back in the charger holder. After
setting the timer for charging again, insert
the charge coupler into the charge port
on the vehicle.
(3) Charging and preheating/precooling
for vehicle interior
The battery charge timer can also be
used to preheat/precool the vehicle interi-
or.
PROCEDURE
1. Push the "TIME SET" button to show
the current time on the display. If the
displayed time is not correct, enter the
correct time with the "H" and "M" but-
tons.
2. Push the "TIME SET" button again to
show the charge start time on the dis-
play. To change the start time, enter
the desired start time with the "H" and
"M" buttons.
3. Push the "TIME SET" button again to
show the preheating/precooling start
time on the display. To change the
time, enter the desired start time with
the H" and M" buttons in consider-
ation with the time you start driving.
Move the temperature selector lever
toward WARM" or COLD". You do
not need to operate the fan speed
selector at this time.
To Next Page
Loading...
