Toyota RAV4 2000 - Page 39

29
4. Push the "TIME SET" button again.
The display goes out and the timer
setting completes.
If you fail to push the TIME SET" button
here, the timer cannot be set.
5. Push the "TIMER CHARGE" button.
The charger enters the timer charging
mode and the "TIMER CHARGE" light
comes on.
6. Push the PRE A/C" button.
7. Insert the charge coupler within 3 min-
utes from step 5.
Charging starts and stops automatically
when the traction batteries are charged.
To cancel the timer setting, push the
TIMER CHARGE" button again.
If you insert the charge coupler after the
set start charging time, charging starts at
the set time of the next day.
8. To stop charging in the middle of the
operation, pull out the charge coupler.
Do not remove the charge coupler until
the preheating/precooling start time. The
TIMER SET" function on the vehicle will
be canceled.
If the charge coupler is removed from the
charge port before the SET TIME" func-
tion is activated, perform the following
steps.
D Place the charge coupler back in the
holder of the EVSE to reset the timer
unit.
D Reset the TIME SET" function for the
appropriate time.
D Insert the charge coupler back into the
charge port.
(4) Setting preheating/precooling for
vehicle interior only
PROCEDURE
1. Push the "TIME SET" button to show
the current time on the display. If the
displayed time is not correct, enter the
correct time with the "H" and "M" but-
tons.
2. Push the "TIME SET" button again to
show the charging start time on the
display. Push the H" button several
times until −−−" is displayed.
3. Push the "TIME SET" button again to
show the preheating/precooling start
time on the display. To change the
time, enter the desired start time with
the H" and M" buttons in consider-
ation with the time you start driving.
Move the temperature selector lever
toward WARM" or COLD". You do
not need to operate the fan speed
selector at this time.
4. Push the "TIME SET" button again.
The display goes out and the timer
setting completes.
5. Push the "TIMER CHARGE" button.
The charger enters the timer charge
mode and the "TIMER CHARGE" light
comes on.
6. Push the PRE A/C" button.
7. Insert the charge coupler within 3 min-
utes from step 5.
To cancel the setting, push the "TIMER
CHARGE" button again.
If you insert the charge coupler after the
set start charging time, charging starts at
the set time of the next day.
8. To stop preheating/precooling in the
middle of the operation, pull out the
charge coupler.