TOYOTA ─ Remote Engine Starter Page 19
OPERATION (PRIMARY FEATURES)
LOW BATTERY POWER INDICATOR (TYPE A)
If the button is pressed when the battery of the accessory remote control has run out of
power, the battery LED flashes or switches on.
The table below outlines the remote control operation condition based on LED indicator.
LED indicator Buzzer sound Operation condition and recovery method
Off
*1
Melody The remote control can be operated.
Flashing red
Declining melody
Operation is possible, but range and success rate
may be affected. It is recommended to replace the
batteries with new ones at your earliest
convenience.
Solid on and
red
Declining melody
Operation may not be possible. Replace the
battery. It is recommended to immediately replace
the batteries with new ones.
No light (off)
No melody Operation is not possible. Replace the battery.
*1 When the battery power level is normal, the battery LED does not turn on or flash, when
the button is pressed.
NOTE: Depending on the following usage conditions, the voltage of the battery may drop temporarily,
and the battery LED may turn on. This is due to battery performance characteristics and is not
considered remote control malfunction.
・When the remote engine control is used in cold conditions.
・When the remote engine control was used continuously for a short time.
NOTE: Depending on the usage or storage conditions of the accessory remote control, the battery LED
may not work in the following order: flashing, on, and off.
To Next Page
Loading...
