TOYOTA ─ Remote Engine Starter Page 26
TROUBLESHOOTING INFORMATION
ACCESSORY REMOTE CONTROL (TYPE A)
The following operation conditions may be considered malfunctions. Check the items on the
table first. If problems are not resolved after taking appropriate measures, consult with your
Toyota dealer.
Condition 1: The engine will not start by using the Accessory Remote Control (TYPE A) even after
numerous attempts.
Possible cause Remedy
The remote engine start operation was
attempted while the accessory remote
control was held horizontally.
Perform remote engine start command while
holding the accessory remote control
vertically.
Holding the Accessory Remote Control
horizontally weakens the antenna signal
transmission.
Accessory remote control was used while the
LED was still on or flashing.
Wait for a moment and try again.
NOTE: It may not be possible to use the
Remote Engine Starter while the LED is on
or while previous wireless signal
transmission or reception has not been
completed.
Location where the remote control was used. Move to a different location, wait for a while,
and then try again.
The starter may be affected by radio
interference or reflection depending on the
location or time.
Accessory remote control was used in a
higher location (upper floor of a building) or a
place with many obstacles.
Avoid a location with many obstacles as
much as possible and move so the starter
can be used in a good line of sight.
Reflection and other effects may make it
difficult for the radio waves to reach the
vehicle.
To Next Page
Loading...
