50
Automatic High Beams (AHB)
ACTIVATING THE AHB SYSTEM
CONDITIONS WHERE AHB WILL TURN ON/OFF AUTOMATICALLY
When all of the following conditions are met, the high beams will be automatically
turned on (after approximately 1 second):
• Vehicle speed is above approximately 21 mph (34 km/h) or more.
• The area ahead of the vehicle is dark.
• There are no oncoming or preceding vehicles with headlights or taillights turned
on.
• There are few streetlights on the road ahead.
If any of the following conditions occur, the high beams will be automatically turned off:
• Vehicle speed drops below approximately 17 mph (27 km/h).
• The area ahead of the vehicle is not dark.
• Oncoming or preceding vehicles have headlights or taillights turned on.
• There are many streetlights on the road ahead.
The Automatic High Beams (AHB) safety system is designed to help you see
more clearly at night. At speeds above 25 mph, AHB can detect the headlights of
oncoming vehicles and taillights of preceding vehicles, then automatically toggles
between high and low beams accordingly.
See www.toyota.com/safety-sense for more information.
Refer to the Toyota Owner’s Manual for additional information on AHB operation,
settings adjustments, limitations, and precautions before attempting to use it.
(2)
(1)
(1) Press the “ ” switch.
(2) Turn the headlight switch to the the “AUTO” or “
” position.
The AHB indicator will come on when the headlights are turned on automatically
to indicate that the system is active.
Note: Push the lever away from you to manually turn on high beams. Press the
AHB switch to turn the AHB system off.
The AHB indicator will turn off and “
” or “ ” will turn on. To activate the
system again, pull the lever its original position or press the “
” switch.
TOYOTA SAFETY SENSE
™
TEMPORARILY SWITCHING TO THE LOW BEAMS
Pull the lever toward you and then return it to its original position to switch to the
low beams temporarily.
The high beams are on while the lever is pulled toward you, however, after the lever
is returned to its original position, the low beams remain on for a certain amount of
time. Afterwards, the Automatic High Beams will be activated again.
NOTE: It is recommended to switch to the low beams when the high beams
may cause problems or distress to other drivers or pedestrians nearby.
Using an intelligent camera, Road Sign Assist (RSA) is designed to detect speed
limit signs, stop signs, do not enter signs and yield signs, and display them on the
Multi-Information Display (MID).*
* All vehicle actions must be driver-initiated and are not automated.
Refer to the Toyota Owner’s Manual for additional information and limitations.
RSA DISPLAY
When the driving support system
information display is selected, a
maximum of 3 signs can be displayed.
MY22_Venza_QRG_V2_ML_1110_PRINT.indd 50 11/11/21 11:45 PM
To Next Page
Loading...
Need help?
General
