Quick Installation Guide
AD7200 Multi-band Wi-Fi Router
Connecting the Hardware
Turn on the modem, and
then wait about 2 minutes
for it to restart.
Connect the modem to the
Internet port on your router with
an Ethernet cable.
If your Internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the router’s Internet port, then follow steps 5 and 6 to
complete the hardware connection.
Router
Modem
Power adapter
7106506096 REV1.0.1
Turn off the modem,
and remove the backup
battery if it has one.
2
Place the router horizontally and extend the
antennas to the maximum angle.
1
Note: For best performance, horizontal installation is recommended.
Antenna direction and position can affect performance in vertical
installation situations.
4
3
Turn on the router.
5
Verify that the following LEDs are on and stable before continuing with
the configuration.
6
Internet
On
Internet5GHz
On
60GHz
On
Power
On
2.4GHz
On
AD7200
Note:
1. If all the LEDs are off, press the LED On/Off button for 1 second, then check the LEDs again.
2. If the 2.4GHz, 5GHz, and 60GHz LEDs are off, press the Wi-Fi On/Off button for 2 seconds, then check the
LEDs again in a few seconds.
Power adapter
To Next Page
Need help?
General
