TP-Link ARCHER C1200 - Page 12

7
Chapter 2 Connect the Hardware
5. Verify that the following LEDs are on and solid before continuing with the configuration.
On
Power
On
Internet
2.4G
On
5G
On
Note:
If the 2.4G LED
and 5G LED are off, please press the WPS/Wi-Fi On/Off button for 2 seconds and check the
LEDs again a few seconds later.
6. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
Ethernet cable

• Method 2: Wirelessly
1 ) Find the SSID (Network Name) and Wireless Password printed on the label at
the bottom of the router.
2 ) Click the network icon of your computer or go to Wi-Fi Settings of your smart
device, and then select the SSID to join the network.
C
onnections are availabl
e
W
ireless Network
C
onnectio
n
Connect automatically Connect

TP-Link_XXXX
TP-Link_XXXX_5G
Wi-Fi
Wi-Fi
TP-Link_XXXX
TP-Link_XXXX_5G
CHOOSE A NETWORK...
Other...
< Settings
Smart DeviceComputer
or