Quick Installation Guide
AC2600 Wireless Dual Band Gigabit Router
Connect the Hardware
If your Internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the router’s Internet port, then follow steps 5 and 6 to
complete the hardware connection.
7106505351 REV1.0.0
Verify that the following LEDs are
on and solid before continuing
with the configuration.
6
Power
On
On
Internet
2.4G
On
5G
On
Note: If the 2.4G LED and 5G LED are off, please
press the Wi-Fi On/Off button on the side panel for 2
seconds and check the LEDs again a few seconds later.
Turn on the router.
5
Turn on the modem, and then
wait about 2 minutes for it to
restart.
Connect the modem to the
Internet port on your router
with an Ethernet cable.
Modem
Archer C2600
Power adapter
Power adapter
Turn off the modem,
and remove the backup
battery if it has one.
2
3
4
Internet
For optimum performance,
orient the four antennas as
shown in the drawing
beside.
30° 30°
1 Install the antennas.
To Next Page
Need help?
General
