Quick Installation Guide
AC1350 Wireless Dual Band Router
If your Internet connection is through an Ethernet cable from the wall
instead of through a modem, connect the Ethernet cable directly to
the router’s Internet port, then follow step 4 and 5 to complete the
hardware connection.
Verify that the hardware
connection is correct by
checking these LEDs.
5
2.4G
On
5G
On
On
Internet
Power
On
Note: If the 2.4G LED and 5G LED
are off, please press the Wi-Fi button
on the rear panel for 2 seconds, then
check the LEDs again in a few seconds.
Connect the Hardware
Power adapter
Router
Turn on the router.
4