TP-Link MU-MIMO - User Manual

Quick Installation Guide
MU-MIMO Wi-Fi Router
* Images may dier from actual products.
Set up with videos:
Scan the QR code or visit
https://www.tp-link.com/support/setup-video/#wi--routers
to search for the setup video of your product.
If your internet comes from an Ethernet outlet, connect the router’s WAN port to it, then follow Step 4 and Step 5.
If you want to configure this new router as an access point to extend your network, refer to the Access Point Mode
section on the back page.
Connect the Hardware
On / O
Flip the page over to complete network setup.
Connect the power adapter to
the router and turn it on.
Note: If the 2.4 GHz LED and 5 GHz LED are off, press and hold the
WPS/Wi-Fi button on the back for more than 5 seconds. Both the LEDs
should turn solid.
Power
On
Internet
On
2.4 GHz
On
5 GHz
On
Check for the following LEDs to confirm the
hardware connection, then refer to the next
section to set up the internet.
Modem
Power adapter
Power adapter
Router
Unplug your modem, and remove
the backup battery if it has one.
Connect the powered-off modem
to the router’s WAN port with an
Ethernet cable.
Power on the modem, and
then wait about 2 minutes
for it to restart.
WAN
WAN
POWER
POWER

Summary

Connect the Hardware

Hardware Connection Steps

Step-by-step guide for connecting the modem to the router and powering them on.

Set Up the Network

Setup via TP-Link Tether App

Configure your router using the TP-Link Tether mobile application for easy setup.

Setup via Web Browser

Instructions for accessing the router's web interface to complete network setup.

Access Point Mode Configuration

Configure Router as Access Point

Steps to set up the router to extend your existing wireless network.

TP-Link MU-MIMO Specifications

General

MU-MIMO	Yes
Antenna Type	External
Frequency Band	2.4 GHz and 5 GHz
Wireless Security	WPA/WPA2, WPA-PSK/WPA2-PSK
Ethernet Ports	4 x Gigabit Ethernet ports
Ports	4 x Gigabit Ethernet ports