14
Chapter 2
Set Up Internet Connection
2. Wait until the Signal LED changes to solid on, which indicates that the WPS
connection is successful.
Note:
If the LED does not turn solid on, try again or refer to Method 1: Via the TP-Link Tether App or Method 2: Via a Web
Browser.
3. (Optional) If the extender connects to a dual band router, repeat steps 1 and 2 above
to connect to the other band.
4. Relocate your extender for optimal Wi-Fi coverage and performance.
1 ) Plug in the extender about halfway between your router and the Wi-Fi dead zone.
The location you choose must be within the range of your router.
2 ) Wait for about 2 minutes until the Signal LED turns solid blue. If it doesn’t,
relocate the extender closer to the router to achieve better signal quality.
Router Devices
Halfway
Blue: Suitable location
Red: Too far from router
Note:
To minimize signal interference, please choose a location which is far away from Bluetooth devices and other
household electronic devices, such as cordless phones, microwave ovens and baby monitors.
5. Enjoy! Connect to the extended network and enjoy the Internet.
Extended Network Names:
Router’s network name with _EXT at the end
OR
Same as your OneMesh router
Passwords:
Same as your router
Solid On
To Next Page
Loading...
