14
Option 3: Stick to a clean wall
1. Attach the included adhesive to the back of the
metal plate properly.
2. Wipe o the dust from the surface, stick the metal
plate with the adhesive to the clean wall, and press
it down for 15 seconds to ensure the plate is rmly
attached. Then attach the camera to the plate.
Note: This is applicable with tile, glass, marble, metal,
stainless steel, and hard wall surfaces.
3M
3M
3M Adhesive
Note: The adhesive is for one-time use. Avoid re-using
the adhesive to ensure its adhesion.
1. Stick the mounting template to the desired
mounting place. Drill two holes according to the
template.
2. Insert two anchors into the holes and use the
screws to ax the metal plate over the anchors.
Then attach the camera to the plate.
Option 4. Mount to the wall
6 mm (15/64 in.)
To Next Page
Loading...
