TP-Link Tapo L920 - Resetting Your Light Strip; Soft Reset Procedure; Factory Reset Procedure

20
Reset Your Light Strip
There are two types of reset available: a soft reset which resets the Wi-Fi settings only, and a factory reset that erases all of your custom settings and
restore them to factory defaults.
Soft Reset (without losing the conguration settings except Wi-Fi)
Press and hold the button on your controller for more than 5 seconds but no more than 10 seconds and release. The light strip animating orange and
green after that indicates a successful soft reset. Then you can recongure your light strip in Tapo app.
Factory Reset (back to factory default settings)
Method 1
Press and hold the button on the controller for at least10 seconds until the light strip turns solid white then blinks orange and green. Then you can
recongure your light strip in Tapo app.
Method 2
On the home page in Tapo app, long press the card and tap Remove.
Go to Device Settings page and tap REMOVE at the bottom.
OR