57
Step 5:
Under Tunnel, select Client-to-LAN.
Step 6:
The tunnel supports up to 10 connections, we enter 10 in this example.
Step 7:
Under Encryption, select Enable, and then enter “5678” as Pre-shared Key.
Step 8:
Under IP Address Pool, select “test1” we have added before.
Step 9:
Look for Status, select Active.
Step 10:
Click on Add.
Note:
1) If the IP addresses in the IP Address Pool is not in the same subnet with the VPN router’s
LAN port, the IP address Pool here should choose PPTP2_Dialup_User.
2) In the latest firmware of TP-LINK router, the Enable VPN-to-Internet button is removed
and the VPN feature is enabled by default.
3) DNS setting is not necessary and it can be kept as default. The default IP is “0.0.0.0”,
which means the LAN IP of the router is used as the DNS server address. Or you can enter
the well-known DNS server.
Step 11:
As we enabled Encryption, we need to go to VPN->IPsec, enable IPsec and then click on Save.
To Next Page
Loading...
